The extra kick at the bottom of the face directs run off away from the structure.
Flashing roof stucco house.
Slip the wall leg of the weep screed behind the existing paper.
After the roofing is installed slide the flashing down to the roofing material and seal it well.
After removing the stucco slide a 2x2 galv flashing up behind the paper.
For step flashing with a stucco wall you will be working in part on the roof.
Cut and remove the stucco from where the bottom of the ledger will be to 1 above the plywood.
This drip edge flashing provides protection from water damage along the eaves and rake of a roof.
How to install metal flashing to stucco basic safety tips.
More product details close.
Installing step flashing to stucco walls step 1.
Check out our recommended tools right here.
Considerations before you work.
Add cement and flashing.
If you dont have the step flashing on your shingled ro.
Lay 2x4 blocks on the roof to set a consistent height for the weep screed flashing.
The two main failures are that the product is not applied thick enough which could result in small pinholes that allow water to get in or applying the material when the substrate is not clean.
Gibraltar drip edge flashing can be used with asphalt shingles or metal roofing panels.
Check out our recommended tools right here.
If the flashing you are hoping to install is located high on the walls or on the roof of your home.
Next you will use asphalt or roofing cement.
Flashing that is done improperly can be detrimental to a stucco wall and will cause major issues.
If you ll be adding flashing or replacing existing flashing on your roof first remove.
